Coron Distortion 15

Coron Distortion 15

Project description

Bill of materials

Resistors
R2: 51K
R3: 68K
R4: 510K
R5: 10K
R6: 3.3K
R8: 1.5M
R9: 10K
Potentiometers
R7: 500K Log (A)
R10: 50K Log (A)
Capacitors
C2: 10nF
C3: 2.2nF
C4: 47nF
C6: 10nF
Electrolytes
C1: 10μF
C5: 10μF
DIL IC's
IC1: LM741P
Diodes
D1: Germanium
D2: Germanium
4 jumper wires
9 trace cuts

List

Click here to see the bill-of-materials as a list or download it as a comma separated values file (.csv).

Code

BB Forum code
HTML code

Comments

VERIFIED....

When you build the properly it works.....faithful repro of original Coron 15 which I am lucky enough to own. Nice project, not too complex. I used OA90 diodes, but LEDs or other diodes should work. Also, just use the closest possible values, if you can't get the actual exact ones !

Good luck, it took me a few attempts to get it going, the eyes are not what they used to be.

Circuit verified....no excuses!

Moderators please Ignore my last post about the 741orientation

I will rebuild and confirm whether it works.

Profuse apologies to Harold

This coron 15 strip board layout cannot possibly work

Okay I traced the circuit and feasibly this looks good. But here's the problem, the 741 chip is not mounted directly onto the pcb copper side, it is physically mounted, as should all of the components be, from the non copper strip board side and soldered onto the copper side where the legs poke through. The 741 chip correctly has the number 1 pin marked with a black circle for orientation purposes, however, this changes when the chip is mounted from the rear ie non copper side, and the legs soldered onto the copper side. whilst orientation is not a problem for all of the 2 legged components, it is for multi egged components. Nicely laid out, just does not work! I am an electronics engineer with 27 years experience, I was building this with my son, when we noticed the problem. I will try and troubleshoot this, one obvious solution perhaps is to reverse the legs on the chip so it is effectively turned upside down.

Please remove I posted this in error

I have since rebuilt this and it works just fine.

Build

Can anyone verify this build.

VERIFIED !!!!

Built it today and it works just fine....I will AB it with a Coron 15 I have sat around, although it looks authentic enough in terms of values of components etc...can't see why it would sound any worse at all. Niceley laid out and very compact. If you are from UK just use the nearest value components. I had to opt for OA90 germanium diodes (this is all Maplin had at the time). Although LEDS / other diodes should work fine as well.

Nice one Harold!!

Thanx!

Thank you for verifying it!

I really should spend more time on DIYL ... :(

Add a comment